Key Features of the Dynaflex Hot Melt Hose:

• Outside diameter 30% smaller
• 17% lower wattage requirements
• 30% more flexibility
• Outside temperature 16% cooler
• Reduced warm-up time
• 40% less weight
• One year warranty
• Competitive hose replacement
  

Hot melt adhesvie supply hoses are electrically-heated, flexible conduits designed for the transfer of hot-melt material from an adhesive supply unit (ASU) to an applicator (head or handgun). Hoses are heated by resistance heaters which are wrapped around the hose core and covered with a high-temperature insulation. Hose temperature is regulated by the ASU's controller. A sensor located in the hose provides temperature information to the controller.

DYNACONTROL are 1000 psi (69 bar) hoses used to deliver hot-melt material from a Dynamelt or Dynamini ASU to an ITW Dynatec applicator (either a dispensing head or a hand-held applicator). These hoses provide through wiring for power, sensor and chassis ground in the applicator. All DynaControl hoses feature PT-100 RTD sensors.

Wash down hot melt hose models are available. They consist of a standard hot melt hose, made water resistant with the addition of a seamless flexible sleeving, sealed end cuffs and liquid-tight electrical conduit and fittings.

Hot Melt Hose Product Literature Downloads:

Fast Brochure Download (PDF)

High Res Brochure Download

Gemini Adhesive Hose Service and Operating Manual

Service and Operating Manual Spanish

Stop a $27,000 Line Down-Time Crisis Due to a Hot Melt Hose Faliure. Meet The Gemini Hose With Back-Up Reliability ... Built-in! Heaters or temperature sensors are the primary cause for adhesive hose faliures. Approximently 45 minutes is required for a hose change-out with an average line down time cost of $600/minute